| Measurement functions |
DC mode: Waveform monitor output, DC〜10MHz ±3dB
AC mode: Detection of power line surge noise, 1kHz〜10MHz ±3dB
RMS mode: Rectified RMS output of DC and AC voltages, DC, 40Hz〜100kHz, Response speed: 200 ms or less (400 V AC) |
| Input type |
Balanced differential input |
| Output |
Voltage division ratio: 1/1000, BNC terminal (DC/AC/RMS 3-mode selectable output) |
| DC amplitude accuracy |
±1% f.s. (1000V DC or less), ±3% f.s. (2000 V DC or less) (f.s.=2000 VDC) |
| RMS amplitude accuracy |
±1% f.s. (DC, 40Hz to 1kHz), ±4% f.s. (1 kHz to 100 kHz) (f.s.=1000 VAC) |
| Input resistance, capacity |
H-L: 9 MΩ, approx 10 pF (C at 100 kHz)
H-case, L-case: 4.5 MΩ, approx 20 pF (C at 100 kHz) |
| Max. allowable input |
2000V DC, 1000V AC (CAT II), 600V AC/DC (CAT III) |
| Max. rated voltage to earth |
When using grabber clip: 1500V AC/DC (CAT II), 600V AC/DC (CAT III)
When using alligator clip: 1000V AC/DC (CAT II), 600V AC/DC (CAT III) |
| Power consumption |
- AC ADAPTER 9418-15 (DC 12 V±10%) *1
- Power supply through POWER CORD 9324 connected to logic connector on MEMORY HiCORDER, under certain conditions.
- Power supply through POWER CORD 9325 connected to sensor connector on F/V UNIT 8940.
- Power supply through POWER CORD 9328 connected to DC jack on Input UNIT 8950/ 8952/ 8953/ 8955, for the MEMORY HiCORDER 8855.
- Power supply through POWER CORD 9248 connected to the PROBE POWER UNIT 9687, for MEMORY HiCORDER 8860-50/ 8861-50.
| *1 |
Operating voltage range: +5 to +12V, less than 300mA. DC jack OD 5.5 mm, ID 2.1 mm |
|
| Dimensions, mass |
70 mm (2.76 in) W × 150 mm (5.91 in) H × 25 mm (0.98 in) D, 350 g (12.3 oz) |
| Cable length |
Main unit cable 1.3m (4.27ft), input section cable 46cm (1.51ft) |
| Supplied accessories |
Grabber clips9243 × 1 (Red/Black each one), Alligator clips × 2, Carrying case 3853 × 1 |
